fix · Weber
Weber Spirit E-210 flavorizer bars Three 15.3-inch bars for front-control Spirit 200 / E-210. Why a five-bar 7636 E-310 kit will not sit, and how to seat peaks over two tubes.
easy PT30M Spirit E-210 Spirit II E-210 Updated 2026-08-31
On this page Done versus dirty Procedure Shop
Verified replacements — we don’t stock these
Confirm fit against your data plate and the retailer’s diagram before you buy.
We may earn a commission. No fake prices or inventory.
If none of those match the part in your hand, search instead:
Amazon search · BBQGuys
Top-down gas firebox layers Cooking grates on top, inverted-V flavorizer bars over the burner tubes, electrode at the left tube. TOP DOWN · GAS FIREBOX 1 cooking grates 2 flavorizer bars 3 burner tubes + ports 4 electrode (left tube) LAYERS (top → bottom) 1 Grates — food sits here 2 Flavorizer / heat tents 3 Burner tubes + ports 4 Electrode at left port Lift grates, then tents, to reach tubes. Gas off. Fig. — Firebox, top down: grates, flavorizer bars, burner tubes, electrode. E-210 flavorizers are a three-bar set (OEM 7635 family) at 15.3” for front-control 2013+. The 310 kit is five narrower bars of similar length. Cramming five into a two-tube box dumps fat into ports and walks in the notches.
Three knobs → E-310 bars .
Done versus dirty
Daylight in the peak: done.
Ends off the notches: done.
Surface rust, peak intact: degrease .
Procedure
Photograph the two tubes and three bars in place.
Measure length and V width. 15.3” × ~3.5” is the 210 story; 15.3” × ~2.6” five-pack is the 310 story.
Use the verified 7635 listing above only if your tape agrees.
Lift old bars. Scrape notches.
Set three new bars with peaks covering both port rows. Sight from the front.
Grates on. Confirm nothing shifted.
If ports are already packed, clean them in the same session. Tubes next: E-210 burners .
Not affiliated with Weber.